![]() Note: if you’re using my case design you’ll have to solder the wires to the Pi after the display is inserted into the case. I used a Raspberry Pi Zero W which is supplied without pin headers, this meant that I was able to fit it in a much smaller space, but does mean I had to solder wiring to the Pi. The first task is to connect the display to the GPIO header on your Raspberry Pi. A free balenaCloud account to setup and manage the Pi.Software to flash an SD card ( balenaEtcher ).The project has been built to run in a Docker container on balenaCloud this means you can deploy the project with only a couple of steps, saving any time-consuming manual package installation or configuration. And, if you want to print your own case, a 3D printer or 3D printing service.SSD1322 OLED display - I used this 2.8” one in yellow from AliExpress.Raspberry Pi Zero W (or Zero 2 W) - I used the version without headers in order to fit it into a smaller case, but others will work too. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |